Toilet Repair and New Toilet Installs in Fort Worth
A running, rocking or leaking toilet usually needs a part, not a whole new toilet. When an old one isn’t worth fixing, we can take it out and install a new one instead.
Request a Plumber
Tell us what's going on and the office will call you back to set a time.
Rather pick a time yourself? Book online
Toilet repair
Is a running toilet worth repairing?
Almost always. A toilet that runs or refills on its own usually has a worn flapper or a fill valve that won’t shut off, and both are small parts to replace. Fort Worth Water suggests a dye test: a few drops of food coloring in the tank, wait 10 minutes, and color in the bowl means a leak.
- Running toilets and fill valves that won’t shut off
- Worn flappers and flush handles
- Leaks at the base and failed wax rings
- Supply line and shutoff valve leaks
- Toilets that rock on the floor
- Weak flushes and frequent clogs
- New toilet installation
- Swapping older toilets for low-flow models
Good to know
When does it make sense to replace a toilet instead?
When the porcelain itself is cracked, when parts for an old model are hard to find, or when it clogs no matter what you do. Older toilets can use as much as 6 gallons per flush, according to EPA WaterSense, and a labeled replacement can cut toilet water use by 20 to 60 percent.
Toilet acting up today?
- If it’s leaking or about to overflow, turn the small valve behind the toilet clockwise until the water stops.
- Lift the tank lid and look: a flapper that won’t seat, or water spilling into the overflow tube, tells us a lot.
- Don’t plunge a bowl that’s full to the rim. Give it time to drain down first.
- Mop up water around the base and watch whether it comes back after the next flush.
- Call (682) 474-0599 or book online, and tell us the toilet’s age if you know it.
The rules
What flush rate does Texas allow on a new toilet?
No more than 1.28 gallons per flush on average. Section 372.002 of the Texas Health and Safety Code set that limit for toilets sold in the state on or after January 1, 2014, and dual-flush models have to average 1.28 across two short flushes and one full one. So any toilet bought new in Texas should already meet it.
1.28gallons per flush, the most a toilet sold in Texas since 2014 may use on average
Before 2014 the state limit was 1.6 gallons per flush, which is still the federal standard. The law sits in Texas Health and Safety Code Chapter 372, and EPA WaterSense labels toilets that use 1.28 gallons or less. The EPA also puts toilets at nearly 30 percent of a home’s indoor water use, so an old one is often the easiest place to save. Fort Worth Water’s Checking for leaks page has the food coloring test, and suggests a new flapper when the old one is torn or worn.
How the visit runs
What happens on a toilet call
- Pick a timeCall us, or choose a slot online through Housecall Pro.
- Heads-up textsA reminder comes ahead of the visit, then a text when the tech is headed your way.
- Look and explainThe tech checks the tank parts, the seal at the floor and the supply line, then explains what failed.
- Repair or replaceYou hear both options with prices, and nothing starts until you pick one.
- Test and tidyThe fix is tested over a few flushes and the bathroom is left clean.
From a customer
What do customers say about toilet repairs?
Joann W. had a leaking pipe by the toilet and wrote: “They came out quick and repaired it. Great communication and excellent service.” That’s the job in a sentence: find where the water is coming from, fix that part, and keep you posted along the way.
“Gary is so knowledgeable and cost efficient. He saved me money on future problems as well as fixing my current issues!”
FAQ
Toilet Repair and Installation, Answered
Why does my toilet rock on a slab floor?
Usually the wax ring has compressed or the bolts at the flange have loosened, and sometimes new tile left the floor uneven. On a slab, the flange sits in the concrete, so a loose one gets reset or repaired rather than screwed into a joist. A rocking toilet can break its seal and leak at the base, so fix it early.
Why is there water on the floor around the toilet?
Look at where it starts. Water at the base after a flush usually points to a failed wax ring. Drips from the tank bolts or the supply line show up beside or behind the toilet, and a sweating tank in humid summer weather can drip too. Each has a different fix, which is why the tech checks before quoting.
Is a toilet that clogs every week a toilet problem or a drain problem?
It can be either. An old or worn toilet may not move enough water to clear its own trap, which is a toilet problem. If the toilet clears but the tub or sink nearby gurgles or backs up too, the clog is farther down the line, and that’s a drain cleaning job.
Why won't the valve behind my toilet turn?
Those small shutoff valves can go years without being touched, and minerals in hard water stiffen them in place. Forcing one can crack it or start a drip at the stem. If yours won’t budge, close the main valve for the house instead, and have the stop replaced when the toilet gets fixed.
What comes with a new toilet installation?
The old toilet comes out, the flange gets checked, and the new one is set on a fresh seal, bolted down and connected to the water supply. If the shutoff valve or supply line is old, it’s worth replacing them at the same time. You’ll know what’s included and the price before the old toilet is pulled.
Service area
What area do you cover for toilet repair?
Toilet repairs and installs are part of the plumbing we do from 1923 Golden Heights Rd in Fort Worth and 108 W Lemon St in Saginaw. Homeowners call us from Fort Worth, Saginaw, North Richland Hills, Watauga, Roanoke, Benbrook and Mansfield. Everywhere else we go is on the service areas page.
- Fort Worth, TX
- Saginaw, TX
- North Richland Hills, TX
- Watauga, TX
- Blue Mound, TX
- Lake Worth, TX
- Sansom Park, TX
- Azle, TX
- Springtown, TX
- Reno, TX
- Rhome, TX
- Haslet, TX
- Keller, TX
- Roanoke, TX
- Haltom City, TX
- Southlake, TX
- Hurst, TX
- Euless, TX
- Bedford, TX
- Grapevine, TX
- Arlington, TX
- Mansfield, TX
- Burleson, TX
- Benbrook, TX
- Granbury, TX
- Weatherford, TX
- Crowley, TX
- Everman, TX
- Rendon, TX
- Joshua, TX
- Godley, TX
- Alvarado, TX
- Keene, TX
- Venus, TX
- All service areas
Related services
Other bathroom plumbing we handle
Talk to Eric's team
Toilet running, leaking or clogging?
Give us a call at (682) 474-0599, or grab a time online. We’ll find the failed part, tell you the price, and repair or replace it once you say go.


