Heat Pump Installation for Fort Worth & Saginaw Homes
One system that cools through 100°F summers and heats through cold snaps, sized for your house and put in by Eric’s install crew. Dual-fuel setups with a gas furnace are an option too.
Request Service
Tell us what's going on and the office will call you back to set a time.
Rather pick a time yourself? Book online
Heat pump installation
Is a heat pump a good fit for a Fort Worth home?
For many homes, yes. It cools all summer, runs in reverse to heat in winter, and most winter nights here are mild enough for it to carry the house. On the coldest nights it leans on backup heat or, in a dual-fuel setup, a gas furnace. ENERGY STAR calls heat pumps more efficient than a furnace, even in winter.
- Heat pump replacement
- Dual-fuel systems with a gas furnace
- Sizing the system to the house
- New outdoor unit on a new pad
- Line set and disconnect hookup
- Thermostat setup for heat pump and backup heat
- Outdoor unit placement and drainage
- Financing through three partners
Good to know
Should I keep my gas furnace as a backup?
That’s the dual-fuel option, and it’s worth a look if the house already has gas heat. The heat pump covers mild weather, and the furnace takes over on the coldest nights instead of electric backup strips. Without a furnace, the heat pump is paired with electric backup heat. The tech will price both setups for your house.
Before your heat pump estimate
- Pull a few electric bills, one winter and one summer, to compare against a new unit’s ratings.
- Photograph the data plates on both the outdoor unit and the indoor unit.
- Check whether the house has gas service. That decides whether dual-fuel is on the table.
- Walk the outdoor unit’s spot and note standing water, crowding shrubs or a roof edge that dumps rain on it.
- Call (682) 474-0599 or book online, and ask to see the SEER2 and HSPF2 numbers for every option.
The rules
What efficiency does federal law require for a new heat pump?
At least 14.3 SEER2 and 7.5 HSPF2 for a split-system heat pump made on or after January 1, 2023, under U.S. Department of Energy standards. Single-package heat pumps need 13.4 SEER2 and 6.7 HSPF2. Unlike central air conditioners, heat pumps have one nationwide minimum, so Texas has the same floor as every other state.
7.5 HSPF2the federal heating minimum for split-system heat pumps made since 2023
The numbers come from DOE’s 2023 central air conditioner and heat pump standards guidance, which notes that SEER2 and HSPF2 are close to the old SEER and HSPF ratings but not directly comparable. A higher HSPF2 means less electricity used to heat the house. Sizing matters as much as the rating: ENERGY STAR advises having the contractor confirm the size with a Manual J calculation. Ask the tech where each model you’re considering lands.
How the visit runs
How a heat pump install is handled
- Visit and measureBook by phone or online, then the tech or Eric looks at the house, ducts and current equipment.
- Choices on paperOptions with their ratings and prices, dual-fuel included where there's gas.
- Texts on install dayA reminder ahead of time, and a text when the crew is heading over.
- Set and connectThe outdoor unit goes on its pad, and the line set and disconnect are hooked up.
- Tested both waysThe crew runs it in heat and cool, cleans up, and explains the Protection Club.
From a customer
What do customers say after a full system replacement?
Janet G. wrote, “I had to replace HVAC system back in August,” and said “the install was quick.” Her review goes on to the follow-up visit: “The heat inspection was today.” Pat K. had a “complete system replaced by Eric’s team” and said a later issue was one “which they took care of immediately.”
“OMG Ezekiel is so professional. He was able to guide me all the way through my heating system. That was a good experience with him.”
FAQ
Heat Pump Installation Questions
Will a heat pump keep up during a freeze like February 2021?
It will need help on nights like that. DFW reached -2°F on February 16, 2021, per the National Weather Service, and every heat pump loses capacity as the air gets that cold. That’s what backup heat strips or a dual-fuel furnace are for. On most winter nights here, a properly sized heat pump carries the house without them.
Is an ENERGY STAR heat pump worth the extra cost?
Often, for a system that runs as many months as a heat pump does here. ENERGY STAR split systems must reach at least 15.2 SEER2 and 7.8 HSPF2, above the federal minimum, and ENERGY STAR says the price difference is paid back over time through lower energy bills. The tech can price a minimum unit and an ENERGY STAR one side by side.
Do I need new ductwork with a new heat pump?
Not always. If the ducts are sealed, sized well and in decent shape, they can stay. Attic ducts can get crushed, torn or loose at the joints over the years, though, and a new heat pump can’t make up for air lost in the attic. The tech checks the ducts during the visit and tells you what they see.
How do I pay for a new heat pump over time?
Through the three partners on our financing page, if you’d rather not pay all at once. Credit Hub by Watercress Financial offers home-improvement loans, Chowder Financial offers lease-to-own, and MicroF RTO offers rent-to-own. Each partner sets its own terms and approval, so apply before the install is scheduled.
Where should the outdoor unit go?
Usually where the old one sat, on a level pad with open air around it. A heat pump drips meltwater during winter defrost, so the spot shouldn’t send water across a walkway where it can freeze. Keep shrubs and fences back from the coil, and avoid a spot under a roof edge that dumps rain on the unit.
Service area
Where do you install heat pumps?
In both halves of our service area. Near the railroad tracks in old-town Saginaw, the W Lemon St office covers Saginaw, Blue Mound, Lake Worth, Sansom Park, Azle, Rhome and Roanoke. The Golden Heights Rd office handles the city of Fort Worth plus Haslet, Keller, Hurst, Benbrook, Weatherford and Granbury. The service areas page has every town.
- Saginaw, TX
- Fort Worth, TX
- Haslet, TX
- Weatherford, TX
- Blue Mound, TX
- Lake Worth, TX
- Sansom Park, TX
- Azle, TX
- Springtown, TX
- Reno, TX
- Rhome, TX
- Keller, TX
- Roanoke, TX
- Watauga, TX
- North Richland Hills, TX
- Haltom City, TX
- Southlake, TX
- Hurst, TX
- Euless, TX
- Bedford, TX
- Grapevine, TX
- Arlington, TX
- Mansfield, TX
- Burleson, TX
- Benbrook, TX
- Granbury, TX
- Crowley, TX
- Everman, TX
- Rendon, TX
- Joshua, TX
- Godley, TX
- Alvarado, TX
- Keene, TX
- Venus, TX
- All service areas
Related services
Related systems and repairs
Talk to Eric's team
Thinking about a heat pump?
Ring (682) 474-0599 or book online, and a tech will come measure. Each option comes with its SEER2 and HSPF2 ratings and its price before you choose.

